ML 220 - Technical Information

 ML 220 Main Page | ML 220 Downloads

Features:

The ML 220 has maintenance-free bearings, no flexible hoses (all zinc-plated steel pipes), no exposed cylinder rods which could be damaged or ingest dirt.  Damage in the event of accidents is inexpensive to repair because of this models very simple design, which also makes it easy to maintained.


Dimensions:

 

The mounting space on the vehicle body must provide the following dimensions conforming to DIN30731 (see figure above): Width = 1426 + 2mm Aperture width = 1400 mm minimum

The given minimum dimensions regarding the safety clearances of the lifter must be respected (see figure above). No part of the powerful compactor system shall approach the lifter to less than 200mm. A log, for example, trapped between the compactor and lifter, will cause damage to the lifter. Our experience shows that a 200mm clearance is sufficient to avoid these incidents.

Specifications:

 BIN TYPE:

2 x 240 litre per lifter

 CYCLE TIME:

7 - 8 seconds

 TIPPING ANGLE:

55 degrees

 LIFTING CAPACITY:

2 x 150 kg (adjustable limit)

(exceeds bin rating by 50 %)

 HYDRAULIC PRESSURE:

130 bar

(relief valve set at 150 bar)

 HYDRAULIC FLOW:

18 litre per minute for 8 seconds cycle time

 NOISE LEVEL:

< 72 dBA

Optional extras:

Electronic monitoring and counting of the lifts, etc.

Dual controls fitted to left hand side of the lifter.

All information given here is subject to change without notice.  Certified specifications will be provided on request.


Copyright © 2016 Mechlift (Pty) Ltd. All rights reserved.

Home

Products

ML 150 ML 220 ML 220R ML 325 ML 325R ML 410 ML 450 ML 805 OEM Services

Misc. Docs & Video Contact Us

MECHLift